Iei-integration NOVA-PV-D4251_D5251 v1.01 Instrukcja Użytkownika Pobierz pdf (Strona 79)

NOVA-PV-D5251/D4251 5.25" SBC

Page 65

Before and during the installation of the NOVA-PV-D5251/D4251 DO NOT:

 DO NOT remove any of the stickers on the PCB board. These stickers are

required for warranty validation.

 DO NOT use the product before verifying all the cables and power connectors

are properly connected.

 DO NOT allow screws to come in contact with the PCB circuit, connector pins,

or its components.

4.3 SO-DIMM Installation

To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.

Figure 4-1: SO-DIMM Installation

Step 1: Open the SO-DIMM socket handles. Open the two handles outwards as far as

they can. See

Figure 4-1.

Step 2: Align the SO-DIMM with the socket. Align the SO-DIMM so the notch on the

memory lines up with the notch on the memory socket. See

Figure 4-1.

Step 3: Insert the SO-DIMM. Once aligned, press down until the SO-DIMM is properly

seated. Clip the two handles into place. See

Figure 4-1.

Step 4: Removing a SO-DIMM. To remove a SO-DIMM, push both handles outward.

The memory module is ejected by a mechanism in the socket.Step 0:

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 178 179

Brak uwag

Iei-integration NOVA-PV-D4251_D5251 v1.01 Instrukcja Użytkownika Strona 79