Iei-integration WAFER-LX v1.22 Instrukcja Użytkownika Pobierz pdf (Strona 85)

WAFER-LX Motherboard

Page 67

 The SO-DIMM socket supports SDRAM DIMM speeds of 333 MHz and

400 MHz

5.4.1.2 DIMM Module Installation

The WAFER-LX motherboard has two DDR SDRAM DIMM sockets. To install the DIMM

modules, follow the instructions below.

Step 1: Locate the SO-DIMM module connector.

Step 2: Push the SO-DIMM chip into the socket at an angle. (See

Figure 5-1)

Step 3: Gently pull the arms of the SO-DIMM socket out and push the rear of the

SO-DIMM module down. (See

Figure 5-1)

Step 4: Release the arms on the SO-DIMM socket. They clip into place and secure the

SO-DIMM module in the socket. Step 0:

Figure 5-1: SO-DIMM Module Installation

5.4.2 Peripheral Device Connection

Cables provided by IEI that connect peripheral devices to the motherboard are listed in

Table 5-1. Cables not included in the kit must be separately purchased.

Quantity Type

1 Audio cable

1 IDE flat cable 44P/44P

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 226 227

Brak uwag

Iei-integration WAFER-LX v1.22 Instrukcja Użytkownika Strona 85