Iei-integration IMBA-C604EP Instrukcja Użytkownika Pobierz pdf (Strona 70)

IMBA-C604EP ATX Server Board

Page 54

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX power mode selection JATX_AT1 2-pin header

Clear CMOS jumper CMOS_CLR1 2-pin header

USB power selection jumpers USB_PWR1,

USB_PWR2,

USB_PWR3,

USB_PWR4,

USB_PWR5,

USB_PWR6

3-pin header

Table 4-1: Jumpers

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 211 212

Brak uwag

Iei-integration IMBA-C604EP Instrukcja Użytkownika Strona 70