Iei-integration UPC-V312-D525 v1.10 Instrukcja Użytkownika Pobierz pdf (Strona 41)

UPC-V312-D525 Panel PC

Page 28

Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel PC.

Step 0:

3.6.2 Stand Mounting

The UPC-V312-D525 can be installed on any stand that supports the standard VESA

mounting interface. An example stand is shown below.

Figure 3-10: VESA Compliant Stand

To install the UPC-V312-D525 on the stand, follow the directions below.

Step 1: Locate the screw holes on the rear of the UPC-V312-D525. This is where the

stand bracket will be attached. The stand mount retention screw holes are

shown in

Figure 3-7.

Step 2: Align the bracket with the screw holes.

Step 3: Insert the retention screws into the screw holes to secure the bracket to the

UPC-V312-D525. Step 0:

3.6.3 Wall Mounting

To mount the panel PC onto the wall, please follow the steps below.

Step 1: Select the location on the wall for the wall-mounting bracket.

Step 2: Carefully mark the locations of the four brackets screw holes on the wall.

Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention

screws.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 174 175

Brak uwag

Iei-integration UPC-V312-D525 v1.10 Instrukcja Użytkownika Strona 41