Iei-integration AFL2-W10A-N28 Instrukcja Użytkownika Pobierz pdf (Strona 48)

AFL2-W10A-N28 Panel PC

Page 30

3.11.2 Panel Mounting

To mount the AFL2-W10A-N28 flat bezel panel PC into a panel, please follow the steps

below.

Step 1: Select the position on the panel to mount the flat bezel panel PC.

Step 2: Cut out a section corresponding to the size shown below. The size must be

smaller then the outer edge.

Figure 3-15: Cutout Dimensions

Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the

panel.

Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on

the rear of the panel PC.

Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting

the four retention screws into the VESA mounting holes (

8Figure 3-16

Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets

(

8Figure 3-16

). There are a total of 4 panel mounting clamps for

AFL2-W10A-N28.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 205 206

Brak uwag

Iei-integration AFL2-W10A-N28 Instrukcja Użytkownika Strona 48