Iei-integration AFL2-17A-H61 v1.23 Instrukcja Użytkownika Pobierz pdf (Strona 84)

AFL2-17A/AB-H61

Page 64

5.13.2 Panel Mounting

To mount the AFL2-17A/AB-H61 flat bezel panel PC into a panel, please follow the steps

below.

Step 1: Select the position on the panel to mount the flat bezel panel PC.

Step 2: Cut out a section corresponding to the size shown below. The size must be

smaller than the outer edge.

Figure 5-19: Cutout Dimensions

Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the

panel.

Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on

the rear of the panel PC.

Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting

the four retention screws into the VESA mounting holes (Figure 5-20



Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets

(Figure 5-20



). There are a total of 4 panel mounting clamps for

AFL2-17A/AB-H61.

Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 277 278

Brak uwag

Iei-integration AFL2-17A-H61 v1.23 Instrukcja Użytkownika Strona 84