Iei-integration AFL-W10A-N270 v2.13 Instrukcja Użytkownika Pobierz pdf (Strona 55)

AFL-W10A-N270 User Manual

Page 55

3.4 Memory Module Replacement

The panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory module is

fail, follow the instructions below to replace the memory module.

Step 8: Remove the aluminum back cover. See Section 3.3 above.

Step 9: Locate the DDR2 SO-DIMM on the motherboard (Figure 3-4).

Figure 3-4:AFL-W10A-N270 SO-DIMM Socket Location

Step 10: Remove the DDR memory module by pulling both the spring retainer clips

outward from the socket.

Step 11: Grasp the DDR memory module by the edges and carefully pull it out of the

socket.

Step 12: Install the new DDR memory module by pushing it into the socket at an angle

(Figure 3-5).

Step 13

: Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 3-5).

Step 14

: Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.Step 0:

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 142 143

Brak uwag

Iei-integration AFL-W10A-N270 v2.13 Instrukcja Użytkownika Strona 55